Emergency well service in Reidsville starts with a few safe checks on your end, then a call to us so we can track down the cause.
What emergency well service in Reidsville covers when the taps go dry
When the water stops, the cause nearly always falls into one of four groups: no power reaching the pump, a failed control part, a pump or pipe that has given out, or a well drawn down below the pump intake. A no-water call means sorting out which one, then getting water flowing again.
Sometimes that is a quick fix at the surface, like a pressure switch with burned contacts or a dead start capacitor. Sometimes it means pulling the pump to find a split drop pipe or a motor that has quit. If the well itself is short on water, we measure the level and talk through what that means for the system. Whatever we find, you hear it in plain words, along with what has to happen now and what can wait.
A few no-water calls turn out simpler than they look. A shutoff valve left closed after other work on the house, a sediment filter packed solid with grit, or an exposed line that froze overnight can all stop the water while the pump itself is fine. We rule those out early, because they are quick to check.
Why a dry tap should not wait for a convenient day
A house without water stops working fast. No flushing, no washing up, no water for pets or animals in the barn. Beyond the hassle, a few things get worse the longer they sit.
If the pump is still running against a dry well or a broken pipe, nothing is cooling it, and it can burn itself out. Turning a tripped breaker back on again and again can finish off a motor that might have been saved. A system left empty can pull air and sediment into the lines when it restarts. And if the wellhead was under floodwater, drinking from the system before the well is disinfected and tested is a health risk, not a nuisance.
Telling a power problem from a pump or well problem
- Total silence, breaker on: often a switch, control box, or wiring fault, and sometimes a motor that has stopped for good.
- Breaker trips again as soon as it is reset: something is drawing too much current. Leave it off.
- Pump runs, nothing comes out: think split drop pipe, a failed coupling, or a pump worn out inside.
- Water returns after a rest, then quits again: the well may be giving up water faster than it refills.
- Water went off during or after a storm: lightning damage to the control box, switch, or motor is a strong possibility.
- Pressure faded over a day or two before quitting: often a worn pump or a leak in the drop pipe.
None of these call for opening anything. The point is to tell us what you saw, so we arrive with the right parts on the truck.
What happens once we pull into the driveway
Your story comes first. When the water stopped, whether there was a storm or a power blip, whether the breaker tripped, and what you have already tried.
Then the power. We check the breaker and the voltage reaching the pressure switch and control box. A good number of no-water calls end right here.
Then the controls. Switch contacts, the sensing tube, the start capacitor, and the relay all get tested.
Then the well. Electrical readings taken at the wellhead, plus a measurement of the water level, tell us whether the pump has failed or simply has nothing to pump.
Then the fix. We replace the failed part, or pull and replace the pump if that is what it takes. If the well was opened, it gets disinfected as North Carolina requires before you put the water back in use.
Before we leave. We run the taps, watch the gauge through a full cycle, and walk you through what failed, what we did, and anything else we spotted that could cause the next outage.
Before we reach you: getting a dry house near Reidsville ready
Even the city keeps a backup. The state's 2025 Local Water Supply Plan for the city notes that Reidsville has an emergency purchase connection with Greensboro for its public system. A house on a private well has no connection like that, so the backup is whatever you set up while you wait.
- Reset a tripped pump breaker one time only. If it trips again, the fault is real, so leave it off.
- If the pump is running but no water comes, switch that breaker off so the motor does not run dry.
- Hands off the pressure switch and the control box. There is live current inside both.
- If the wellhead went under water, leave the power off until the floodwater is gone.
- Get drinking water from a neighbor or the store, and keep a bucket handy for flushing.
- Clear a path to the well, the tank, and the electrical panel, and put the dogs inside.
- Jot down what you heard and saw. It shortens the search.
- If anyone in the house depends on water for medical reasons, say so when you call.
Local mail runs through two ZIP codes, 27320 and 27323, and the second is a PO Box ZIP. If your mail goes to a box, give us the street address of the house with the well. A gate code or a landmark at the end of a long driveway helps us find you.
Calling us when the water stops
Weekday calls reach the office from 8am to 5pm. If it is the weekend, call or text (336) 613-4314, say you have no water, and give the street address. We will ask what the pump and the breaker did, so keep your notes close. US 29 runs between Greensboro and Reidsville, so that is usually the way we come. NC 65 is another road through town, and we also work in Eden.
ZIP code we cover around Reidsville: 27320.