Well and Casing Repair in the Piedmont Triad

Well casing repair is about keeping the outside world out of your water.

When steel casing rusts through, a cap works loose, or the top of the well ends up buried in the yard, rain, soil, insects, and bacteria find a way in. We repair casing, install liners, replace caps, and raise buried wellheads on both sides of the North Carolina and Virginia line.

What a well casing is holding back

The casing is the pipe you see standing out of the ground, and it runs a long way down. In most Piedmont wells it passes through the soil and soft weathered rock until it seats in solid rock, and the hole below it stands open. The USGS describes that upper layer as loose material, much of it decomposed rock called saprolite, covering the bedrock almost everywhere in the region. Rain soaks into it far more easily than into the rock below.

The casing keeps that layer, and whatever soaks through it, out of the well. A grout seal around the outside of the pipe stops surface water from running down along it. The cap on top keeps out rain, insects, and small animals while letting the well breathe. When any of those three pieces fails, shallow water that never passed through rock can reach your pump.

Cracked and corroded steel casing

Many older wells were cased with steel. Steel lasts a long time, but it rusts, and it rusts worst near the ground line, where the soil stays damp and air can reach it. First come pinholes, then a seam that opens, then a section thin enough to crush.

The signs usually show up in the water before anyone notices them at the wellhead:

  • Cloudy or muddy water a day or two after a heavy rain.
  • Rust flakes, orange staining, or a metallic taste that gets worse over time.
  • A bacteria test that comes back positive, gets chlorinated, and comes back positive again.
  • New grit in filters or at the taps.

The USGS notes that high iron in Piedmont well water can come from corrosion, or from iron bacteria acting on steel casing and fittings. Rusty water does not always come from the rock.

Casing that ends at or below the ground

Some wellheads disappear over the years. Topsoil gets added, a flower bed grows up around the pipe, or someone cut the casing low and buried the cap to get it out of sight. Every one of these puts the top of your well right where rainwater collects.

North Carolina and Virginia both require casing to end at least 12 inches above the ground. North Carolina's rules add that no well may be repaired so the wellhead ends up lower than that, and that the ground next to it must be graded so surface water runs away from the well. The EPA's advice to well owners is blunt on the same point: never cut the casing off below the land surface.

Extending casing above grade

The fix is to bring the casing back up. We dig out around the wellhead, join a matching length of casing to the old pipe with a sound, watertight connection, fit a new sanitary cap, and regrade so the ground falls away from the well on every side.

Loose caps and the way bacteria get in

A good well cap seals tight to the casing, bolts down, and has a screened vent so the well can breathe as the water level rises and falls. Plenty of caps out there are nothing like that. We find caps that just sit on the pipe, caps cracked by a mower, bolts rusted away, vent screens torn open, and wire entries left unsealed. Every gap is a door for rain, insects, spiders, and mice.

NC DHHS says coliform bacteria and E. coli can get into well water when a well is poorly built, cracked, or unsealed. You cannot see, smell, or taste coliform. Only a lab test finds it, which is why the state advises a yearly bacteria test through a certified lab, and why a positive result should send someone straight to the wellhead.

Virginia Cooperative Extension makes the same point from the other side: bacteria keep coming back if a source like a loose cap or cracked casing is never fixed. Chlorinating a well with a bad cap cleans the water for a while and leaves the opening right where it was.

Sand, silt, and grit coming through the taps

A little sediment now and then is not unusual in a rock well. A steady supply of it means something has changed. In older wells, the usual sources are corroded casing letting soil and weathered rock wash in, a casing that was never seated well into solid rock, or soft rock in the open hole below the casing that crumbles a little more each year.

Grit is hard on everything downstream. It wears the impellers in the pump, scores check valves, settles in the bottom of the pressure tank, plugs the sensing tube on the pressure switch, and clogs filters long before they are due. A sediment filter at the house catches it, and we install those, but a filter does nothing about the source. When grit is coming through the casing or from a caving section of the hole, the lasting fix is a well casing repair or a liner.

Liners for older wells

A liner is a smaller pipe set inside the existing casing. It seals off a section that has rusted through or cracked, so the damaged pipe no longer touches your water. North Carolina's construction rules allow NSF-approved PVC pipe rated at 160 psi to be used as a liner, with the space around it completely filled with cement grout.

Liners also help some older wells where soft rock below the casing keeps caving in and sending grit to the pump. Which approach fits depends on the well, its age, and what the inspection shows. On an old well, a liner is often one part of a bigger job that also brings the wellhead up to code and gets the water tested clean, which is what our old well remediation covers.

Because the pump has to come out for liner work, these jobs usually pair with a look at the pump, the drop pipe, and the wire. If any of it is worn out, better to find out while everything is already out of the hole.

Permits for well repair in North Carolina and Virginia

North Carolina. Repairing a private well takes a permit from the county health department. Pump and tank repairs and replacements are a different category: they need no repair permit, and neither does routine maintenance that leaves the seal alone. The state also requires a certified well contractor to be present for well repair, casing extension, and disinfection.

Virginia. Since November 6, 2024, a written permit has been required to construct, alter, abandon, or deepen a private well. Swapping a cap or seal for an equivalent one, or extending the casing up above the ground, is not an alteration under the state's rules. Other repairs inside the casing may be, and that application goes through the local or district health department. Anyone doing well repair work in Virginia has to be licensed and certified.

We hold North Carolina water well contractor certification 2453-A and Virginia water well license 2719001436.

The longer a bad casing waits, the more it lets in

Casing problems do not heal. Every heavy rain pushes a little more surface water toward a crack or a buried cap. Rust holes widen. Grit keeps grinding at the pump, and a caving section of rock can eventually jam a pump in the well when it is time to pull it.

The water gets worse in ways you cannot always see. Bacteria that ride in with surface water can show up in one test and not the next, which makes it easy to believe the problem has passed while the household keeps drinking from it. A wellhead that stays buried also gets buried deeper as the yard changes, so it is harder to find when something else fails.

There is a hard stop, too. Under North Carolina's rules, broken or defective casing, seals, or wellhead parts must be repaired or replaced, or the well must be permanently abandoned. Wait long enough and repair may stop being one of the choices.

How a well casing repair visit goes

We start at the wellhead with a tape measure and a flashlight. How high the casing stands, what shape the cap is in, whether the ground slopes toward or away from the pipe, and whether there is rust or a crack at the ground line all tell part of the story. We also ask about the water: when it turns cloudy, whether you have a recent bacteria result, and whether grit has started showing up.

Next, with the cap off, we look down the casing and at the wire entry for anything getting in from the top. A water sample for the lab may come next.

Then you get the options in plain terms: a new cap, a casing extension and regrading, a liner, or some mix of those. Any permit comes first, then the work.

Disinfection and testing afterward

Once the work is done, the well gets shock chlorinated. Virginia's rules require disinfection after any work that reaches inside the casing, as do North Carolina's rules whenever a pump is reinstalled. NC DHHS also says to test the water after any well component is repaired or replaced. On permitted work in North Carolina, the health department inspects, and the well cannot go back into service until it issues a certificate of completion.

If your cap is loose, your casing is buried, or a bacteria test keeps coming back positive, call (336) 613-4314.

What is down there, and what can go wrong

Tap a part, or pick one from the numbered list, to see what it does. Press "Run the pump" to watch the water move.

How a private well system works Cutaway of a drilled well: cap and casing above the ground, a pitless adapter below the frost line, a submersible pump hanging in water-bearing bedrock, and a buried line to the house where the pressure tank, pressure switch, control box and treatment sit. TOPSOIL RED CLAY AND WEATHERED ROCK BEDROCK frost line water level
  1. A sealed, vented cap keeps out rain, insects and small animals. A cracked or loose cap is one of the easiest ways for bacteria to get into a well.

    Well Repair, Casing Repair and Well Liners
  2. Pipe that lines the top of the well and seals it from surface water and loose soil. It should stand above the ground, never be buried.

    Well Repair, Casing Repair and Well Liners
  3. The fitting on the side of the casing, below the frost line, where the water line leaves the well for the house.

    Well Pump Troubleshooting and Repair
  4. Sits down in the water and pushes it up to the house. Most drilled wells use one. Shallow wells and some older systems use a jet pump above ground instead.

    Well Pump Installation and Replacement
  5. Carries water up and power down. A split pipe or a bad splice can look exactly like a dead pump.

    Well Pump Troubleshooting and Repair
  6. In the Piedmont, wells draw water from cracks in the bedrock. Hydrofracturing can open more of them in a well that gives too little.

    Well Rehabilitation and Hydrofracturing
  7. Holds water under air pressure so the pump does not start every time you open a tap. A tank that has lost its air makes the pump short cycle.

    Pressure Tank Installation, Replacement and Tuning
  8. Turns the pump on at the low setting and off at the high one. Pitted contacts or a clogged sensing tube stop the whole system.

    Pressure Switch, Control Box and Wiring Repair
  9. Three-wire pumps have a control box on the wall with the start parts. Two-wire pumps do not.

    Pressure Switch, Control Box and Wiring Repair
  10. Filters, softeners and disinfection go after the tank. A lab test tells you which one, if any, you need.

    Well Water Treatment Systems

Well and Casing Repair: common questions

Still stuck? (336) 613-4314

How do I know if my well casing is cracked?

From the outside, look for rust holes or splits at the ground line, a casing that shifts when you push on it, or a cap that will not sit tight. Many cracks sit below the surface where nobody can see them, so the water is often the first clue. An inspection and a bacteria test give you a real answer.

Can I build up the soil around my well so rain runs off?

Not by burying the casing. Piling soil until the pipe stands less than 12 inches above grade breaks the rule in both states and makes the problem worse. The right approach keeps the casing tall and shapes the ground so it slopes away from the well in every direction. If the casing is already too short, it gets extended first.

Does putting in a liner mean I need a new pump?

Not always. A liner narrows the inside of the well, so the question is whether your pump and its fittings will pass through it. We measure the casing and the pump first. If the pump fits and is in good shape, it goes back in. If not, a slimmer pump becomes part of the work, and you hear that up front.

Is a well cap supposed to be airtight?

No. A well has to breathe, because the water level inside moves up and down as you use water and the well refills. A proper cap seals against the casing and keeps out rain and insects, but it has a screened vent built in. If that screen is torn or missing, the cap should be replaced.

How often should I look at my wellhead?

At least once a year, and after any big storm or yard work nearby. NC DHHS suggests owners check the wellhead yearly for cracks or openings, alongside a yearly bacteria test. Look at the cap, the bolts, the vent screen, the casing at the ground line, and which way the soil slopes. Anything loose or cracked is worth a call.

Why is my well water orange or full of rust flakes?

Iron occurs naturally in Piedmont groundwater, so it can come straight from the rock. It can also come from the well, when steel casing or fittings corrode. A water test shows how much iron you have, and a look at the casing tells us whether the well is adding to it. Treatment handles natural iron. Rust from failing casing needs a repair.

Can a lawn mower really damage a well casing?

Yes. A mower deck or a string trimmer catches the cap, cracks it, or knocks it loose, and PVC casing can split near the top. Steel bends less, but a hard hit can still break the seal under the cap. A couple of bright stakes around the wellhead keeps machines at a distance without burying anything.

My well sits in a pit below ground. Is that a problem?

It can be. A pit collects rain and runoff right where the casing ends, and small animals tend to fall in. Both states require casing to end at least 12 inches above the ground, which a pit well usually does not. The usual fix is extending the casing up out of the pit, fitting a sanitary cap, and grading the area so it sheds water.

Good references

Official pages we point homeowners to. They open in a new tab.

No water, low pressure or bad taste?

Call or text. Monday to Friday, 8am to 5pm. Saturday and Sunday: call or text.