Well and Casing Repair in Kernersville, NC

A well casing that has cracked, settled below the yard, or lost its cap lets rainwater run straight down into the well.

Map: Kernersville, NC in relation to GreensboroKernersvilleGreensboro16.1 miColfaxWalkertownOak RidgeHigh PointFORSYTHGUILFORD
Town
Kernersville, NC
County
Forsyth County
From our Greensboro office
16.1 miles, straight line
Open Kernersville in Google Maps

For a Kernersville home on its own well, that can mean bacteria in the tap water with no change in taste or smell. Well casing repair in Kernersville closes that path and brings the wellhead back up to North Carolina rules.

What well casing repair in Kernersville takes care of

Think of the casing as the well's collar. It runs from above the yard down through soft ground until it is seated in rock. USGS calls that soft ground regolith: decomposed rock, loose material, and soil lying over Piedmont bedrock almost everywhere, with water moving through it more easily than through the rock underneath. A sound casing keeps what soaks into that layer out of your water.

Casing repair covers several different problems:

  • Casing that ends too low. North Carolina wants the casing to stand a full 12 inches or more over the ground around it. Pipe that was cut short, or buried when a yard was regraded, gets extended back up.
  • Damage at the top. A mower, a car, or years of rust can crack or bend the exposed pipe.
  • A bad cap or seal. A loose, cracked, or missing cap lets in insects, small animals, and runoff.
  • Leaks lower down. A cracked or corroded stretch below ground can be sealed off with a grouted liner.

Under state law, repair work on a private drinking water well needs a permit from the local health department, and extending casing or breaking the well seal is work for a certified well contractor. We hold the state's water well contractor certification, number 2453-A, and our founder has worked as a licensed tradesman since 1974.

The quiet damage a cracked or buried casing does

Casing trouble does not shut the water off, which is exactly why it gets ignored.

According to NC DHHS, a private well that is poorly constructed, cracked, or unsealed is one of the ways coliform bacteria and E. coli reach the water. Rain that pools around a buried or broken casing carries soil, lawn chemicals, and animal waste with it. Insects and small animals work their way under a loose cap and die there.

When a well's casing, seals, or wellhead fittings are broken, punctured, or otherwise defective, the state's construction standards leave two options: repair or replace the bad parts, or abandon the well permanently. A problem left alone long enough can end with the well being sealed for good.

Yard clues that the casing is letting you down

  • The top of the casing sits at or below the grass, or in a dip that holds water after rain.
  • The cap is cracked, loose, missing bolts, or tilted.
  • The exposed pipe is bent, dented, or rusted through.
  • Soil has settled or a hole has opened up beside the casing.
  • Water that clouds up or runs brown when it storms.
  • Coliform shows up on a lab report.
  • There are insects, webs, or nesting material under the cap.

Bacteria do not change how water looks, smells, or tastes, so the clues out in the yard deserve attention even when the water seems fine.

How a casing repair visit goes, step by step

A look at the wellhead. We look over the exposed pipe, its cap, and the soil around both, measure how high the casing stands above grade, and check which way the yard drains.

A look inside. With power to the pump shut off, the cap comes off so we can see the top of the casing, where the wire enters, and the pitless area. If the trouble is at the top, the fix is at the top. If the signs point to a leak deeper down, a liner comes into the conversation.

The permit. Repairs to the well itself go through the county health department, and we explain that process, including the inspection afterward.

The repair. Short casing gets extended with a proper coupling to at least 12 inches above the ground, and a new sanitary cap goes on. Soil around the wellhead is built up and sloped so rain runs away from it. For a leak below ground, a liner is set and grouted in place.

Disinfection and a test. Opening the well means shock chlorinating it afterward. Once the chlorine is gone, a bacteria test shows whether the repair did its job.

Lot sizes, slopes, and protected watersheds around Kernersville

On land without public water service, the town's development ordinance leaves the minimum lot size for a single-family home to the Public Health Department, and that minimum can be no smaller than 20,000 square feet or the zoning district's own minimum, whichever is larger. The RS-40 and RS-30 districts, written for homes without public water, start at 40,000 and 30,000 square feet. On a lot that size, the well may sit out in open yard, where mowers, driveways, and regrading all happen around it.

Protecting water is written into the town's rules, too. The Watershed Protection Ordinance took effect July 1, 1993, and riparian buffer rules for land in the Jordan watershed and the Randleman Lake watershed followed on July 1, 2011. The Legacy 2030 plan lists Kernersville Lake and Abbotts Creek among Forsyth County's protected water-supply watersheds, and the town's new plan calls for preserving the streamside environment along Abbotts Creek and its tributary.

At the wellhead, all of that comes down to drainage. North Carolina rules call for the ground right next to a wellhead to be sloped so rain and runoff move away from the well. On a sloped lot, or where fill went in around a new driveway, the grade can end up tilting toward the casing. Fixing that slope is part of fixing the casing, because a sealed cap does little good sitting in a puddle.

Setting up a casing inspection or repair

Casing calls go to us at (336) 613-4314 from 8am to 5pm, Monday through Friday, and we find a time. Weekends work by call or text. A texted photo of the wellhead shows us the casing height and cap ahead of time.

We come into Kernersville from the east, the side of town where Triad Park sits, and we look at casings for well owners in Oak Ridge as well.

ZIP code we cover around Kernersville: 27284.

Questions from Kernersville

Still stuck? (336) 613-4314

Does casing repair on a Kernersville well need a Forsyth County permit?

In most cases, yes. State law bars anyone from repairing a private drinking water well without a local health department permit, and for most of Kernersville that office is the Forsyth County Department of Public Health. Once permitted work is finished, the county inspects the well, and it stays out of service until a certificate of completion is issued.

My house is near Kernersville Lake. Does the watershed change anything about my well?

It does not change the basics. Kernersville Lake is listed among Forsyth County's protected water-supply watersheds. For your own well, the rules match the rest of North Carolina: casing at least 12 inches above ground, a secure cap, and soil graded so water heads away from the wellhead.

How large does a lot need to be for a house with a well in Kernersville?

If no public water serves the lot, the town's ordinance lets the Public Health Department set the minimum, no smaller than 20,000 square feet or the district minimum, whichever is greater. RS-40 lots start at 40,000 square feet and RS-30 lots at 30,000. For a specific parcel, ask the town planning office and the county health department.

Can I cut the casing down and bury it under the lawn?

No. EPA advises never cutting a well casing off below the land surface, and state rules forbid any repair or alteration that leaves the wellhead lower than 12 inches above grade. A buried wellhead turns the whole yard into a funnel for runoff. If the casing is in the way, the fix is to work around it, not under it.

Can a cracked casing below ground be fixed without giving up the well?

Often it can, with a liner: a narrower pipe slid down inside the old casing past the damaged stretch. The state's construction rules accept NSF-approved PVC rated at 160 psi for this, provided the gap between the liner and the old casing is packed full of cement grout.

How can I tell whether surface water is getting into my well?

Watch the water after a heavy rain. Cloudiness, a brown tint, or a change in taste that shows up after storms and fades later points to a leak near the top. A positive coliform test is the clearer sign. Then look at the wellhead itself: how high the casing stands, the condition of the cap, and whether water stands around it.

Is the cap on my well good enough?

It depends on the cap. A proper sanitary cap seals tight to the casing with a gasket and has a screened vent, so air can move but insects and runoff cannot. An older cap that just sits on the casing, or one that is cracked or missing bolts, is worth replacing, since it leaves an easy way in.

Is the water safe to drink right after the casing is fixed?

Not right away. The well gets shock chlorinated after the repair, and the chlorine has to be flushed out before normal use. After that, a lab test for coliform bacteria shows whether the repair closed the path for contamination. If bacteria keep turning up after a good repair, there may be another entry point we need to find.

Good references

Official pages we point homeowners to. They open in a new tab.

No water, low pressure or bad taste?

Call or text. Monday to Friday, 8am to 5pm. Saturday and Sunday: call or text.