Well owner tips, November 13, 2026

How to Winterize a Well House Before the First Freeze

The first hard freeze tends to arrive a night or two before anyone is ready for it.

If your pressure tank, switch, or jet pump lives in a well house, a crawlspace, or a shed, look it over in late October. Most of the work takes an afternoon.

The parts of a well system that freeze first

Ice goes after the parts that sit above ground and hold still water.

  • The pressure switch tube. The small pipe under the switch is thin, and the water in it never moves, so it is often the first thing to freeze. Once ice plugs it, the switch cannot read pressure. The pump either will not start or will not shut off.
  • The tank fittings. The tank tee, the gauge, the relief valve, and the short pipes around them have little mass and freeze quickly.
  • A jet pump. The pump body stays full of water. A hard freeze can crack the housing, and a cracked housing usually means a new pump.
  • Exposed line. Any stretch of pipe between the wellhead and the house that runs above ground or through an open crawlspace.

A submersible pump is rarely the problem. It sits down in the well, and the buried line leaves the casing through the pitless adapter below the frost line. What catches people is the short run of pipe and fittings that comes up out of the ground.

Stop the drafts in the well house before you add heat

Moving cold air does more damage than still cold air. A well house with a gap under the door can freeze on a night when a tight one would barely notice.

Walk around it on a windy afternoon and feel for air. The usual leaks are the bottom edge of the walls, the gap around the door, and the hole where the pipe comes through. Foam board, weatherstripping, and a can of expanding foam around pipe openings fix most of it. If the walls and ceiling are bare, insulate them. Then make sure the door latches. A door that blows open at 2am undoes everything else you did.

While you are in there, look for mice. They move into warm well houses in November and chew insulation and wiring. If you find droppings or nesting around the pressure switch or the control box, tell us when you call. Do not pull the cover off to look.

Heat that keeps the tank above freezing without starting a fire

A well house does not need to be comfortable. It needs to stay above 32 degrees Fahrenheit on the worst night of the year, and for most small well houses that takes one of two things.

  • A small heater with a thermostat, rated for damp locations and set just above freezing. Keep it on the floor and away from insulation, cardboard, leaves, and anything else that burns.
  • Heat tape on exposed pipe. Buy tape made for the kind of pipe you have, follow the label on spacing and overlap, and only cover it with insulation if the label allows it.

Plug either one into a grounded outlet with ground-fault protection, not an extension cord lying across a damp floor. Heat lamps can scorch wood and cardboard, so mount one where nothing can fall against it.

Hang a min/max thermometer on the wall so you know how cold it actually got inside.

Leave the wellhead uncovered and the ground sloped

People sometimes stack straw bales, leaves, or old blankets around the wellhead to keep it warm. Skip that. A buried cap hides cracks, holds moisture against the casing, and gives mice a cozy way in.

North Carolina and Virginia rules both call for the casing to end at least 12 inches above the ground. The cap should be tight, uncracked, and bolted down, with the vent screen in place. EPA also advises sloping the ground so runoff moves away from the well. Snowmelt pooling at the casing can seep down along the outside of it.

A well pit or a wellhead that ends below ground belongs on the list for a spring visit. Raising it is worth doing, just not in January.

What to do on a cold morning when the water quits

Cold morning, no water. Start at the pressure tank. If the pump is running and running without the gauge settling where it normally does, turn the pump off at its breaker so it does not overheat. If the gauge reads normal and nothing comes out of the taps, the freeze is somewhere past the tank.

Then warm the space slowly. A space heater set well back from the tank and the switch usually thaws a small freeze in a few hours. Never use a torch or any open flame on pipes, fittings, or the tank.

Once things thaw, check every joint for drips. A split tank or jet pump, a switch that will not start the pump once it is warm, or water spraying anywhere is a reason to call (336) 613-4314.

Quick answers

Still stuck? (336) 613-4314

Does dripping a tap protect the well house?

Not much. A slow drip keeps water moving through lines inside the house, but the tube under the pressure switch never sees that flow, and a tank in a cold room stays cold. Heat and insulation protect the well house. A drip also makes the pump start more often overnight.

Can a pressure tank that froze still be used?

Sometimes. If only the fittings froze and nothing split, the tank may be fine once it thaws. Watch for water at the base and a pump that starts and stops every few seconds, which can mean a torn bladder. A tank with a cracked shell has to be replaced.

Is it safe to leave heat tape plugged in all winter?

Most heat tape with a built-in thermostat is designed to stay plugged in through the cold months, but read the label to be sure. Each fall, check the full length for cracked jackets, scorch marks, or crushed spots. Replace damaged tape instead of taping over it.

How cold does it have to get before I should worry?

Water freezes at 32 degrees Fahrenheit, but the outdoor thermometer only tells part of the story. A tight, heated well house rides out a hard night fine. A drafty one can freeze on a windy night that barely dips below freezing. Several cold nights in a row are harder than one.

Should I wrap the pressure tank in a blanket?

Insulating the room works better than wrapping the tank. A blanket holds moisture against the steel, hides leaks and rust, and does little once the room itself drops below freezing. Put the effort into sealing drafts and keeping a safe heat source in the space.

Does a jet pump in the crawlspace need the same care?

Yes, and sometimes more. Crawlspace vents let in cold air, and a jet pump holds water in its body that can freeze and crack the housing. Close the vents nearest the pump for the winter, insulate exposed pipe, and keep the access door shut tight.

Do I need a permit to replace a tank that split?

Not in North Carolina, where replacing a pressure tank needs no repair permit. The real work is picking a tank sized for your pump and switch, setting its air charge about 2 psi below the cut-in pressure, and protecting the new fittings before the next cold night.

What should I do if the house sits empty for part of the winter?

Keep heat on in both the house and the well house, and ask a neighbor to look in after any hard freeze. Turning the pump off at its breaker limits how much water a broken pipe can spill, but it does not empty the tank or the lines, so heat still matters.

Good references

Official pages we point homeowners to. They open in a new tab.

No water, low pressure or bad taste?

Call or text. Monday to Friday, 8am to 5pm. Saturday and Sunday: call or text.